[Surround Back]
2 spkrs
(Default):
Two Surround Back speakers will be
used.
1 spkr:
Only one Surround Back speaker will be
used. When you select this setting,
connect to the SURROUND BACK L
terminal.
No: Surround Back speakers will not be used.
0
“Front” is fixed as “Yes” as it is required for playback.
0
When “Surround” is set to “No”, “Surround Back” and “Front Wide” settings are
automatically set to “No”.
n
Connection
Select the output terminals for audio from the speakers.
Spkr + Pre-out
(Default):
Speaker and pre-out outputs are active.
Pre-out Only:
Pre-out outputs are active. Speaker
outputs are disconnected for enhanced
audio quality using only the pre-out
terminals.
0
When “Amp Assign” is set to “Preamplifier”, the “Connection” setting of all
speakers will be fixed as “Pre-out Only”.
0
This setting cannot be configured when “Amp Assign” is set to “Custom”.
Contents
Connections Playback Settings Tips Appendix
219
Front panel Display Rear panel Remote Index
To Next Page
Loading...
