Bi-amp connection
o
11.1-channel playback (bi-amp connection of front speakers)
This system plays back 11.1-channels. You can use the bi-amp connection for front speakers. Bi-amp connection is a method to connect separate
amplifiers to the tweeter terminal and woofer terminal of a speaker that supports bi-amplification. This connection enables back EMF (power returned
without being output) from the woofer to flow into the tweeter without affecting the sound quality, producing a higher sound quality.
You can connect speakers for up to 13-channels for MAIN ZONE. When you connect speakers for 12 or more channels, the output speakers
automatically switch according to the input signal and sound mode.
C
SW
RSLS
FHL FHR
RHL RHR
SBL
SBR
FL
(Bi-Amp) (Bi-Amp)
FR
NOTE
0
When making bi-amp connections, be sure to remove the short-circuiting plate or
wire between the speaker’s woofer and tweeter terminals.
wq
(R)
wq
(L)
C
SR SL SBR SBLSW
FHR
FHL
RHR RHL
FR FL
z
1
z
1
z
2
z
2
z
2
z
2
z1
The terminals for bi-amp connections of the front speakers vary depending on
the MAIN ZONE layout. Refer to “Speaker Layout” in the menu. (v p. 216)
z2
The height speakers, ceiling speakers and Dolby Atmos Enabled speakers
can be connected to the HEIGHT1 and HEIGHT2 speaker terminals. Set the
speaker to be connected from “Speaker Layout” in the menu. (v p. 216)
Contents
Connections Playback Settings Tips Appendix
66
Front panel Display Rear panel Remote Index
To Next Page
Loading...
