z1
This item can be selected when using any of the Surround Back, Front Height, Top Front, Top Middle, Top Rear, Rear Height, Front Dolby, Surround Dolby or Back Dolby
speaker. It can also be selected when the “Surround Parameter” - “Speaker Virtualizer” setting is turned “On”.
z2
This can be selected when the Dolby Atmos signal contains the Dolby TrueHD signal.
z3
This item can be selected if the AURO-3D signal contains Dolby TrueHD.
z4
This can be selected when the Dolby Atmos signal contains the Dolby Digital Plus signal.
z5 Selectable when “Surround Parameter” - “IMAX” is set to “Auto” in the menu. (v p. 178)
z6 Selectable when “Surround Parameter” - “IMAX” is set to “Off”. (Selectable sound modes vary depending on the type of input signal). (v p. 178)
z7
This item can be selected if the AURO-3D signal contains DTS-HD.
z8
This item cannot be selected when a DTS(-HD) format with a sampling frequency of over 48 kHz is input.
z9
This item cannot be selected when a DTS:X format with a sampling frequency of over 48 kHz is input.
z10
This item cannot be selected if the sampling frequency of the input signal is 32 kHz.
z11
This item can be selected if the AURO-3D signal contains Multi Channel PCM.
z12
Multi ch In 7.1 can be selected only when the input signals include surround back signals and surround back speakers are being used.
z13
This can be selected when the Dolby Atmos signal contains the Dolby TrueHD or Dolby Digital Plus signal.
Contents Connections Playback Settings Tips Appendix
319
Front panel Display Rear panel Remote Index
To Next Page
Loading...
