Why saved contents cannot be called using the Web Control function on Denon AVC-A1HD Amplifier?
If you cannot call saved content using the Web Control function, it may be because contents saved before the upgrade cannot be called. After completing the upgrade, reconfigure the settings.
Why is there no sound from the monitor connected with HDMI on my Denon AVC-A1HD?
If there is no sound from the monitor connected with HDMI, ensure that the “Manual Setup” – “HDMI Setup” – “Audio” setting is set to “TV”.
General| Type | AV Amplifier |
|---|---|
| Channels | 10.2 |
| HDMI Inputs | 6 |
| HDMI Outputs | 2 |
| Multi-Room Capability | Yes |
| Audyssey | Audyssey MultEQ XT |
| Total Harmonic Distortion | 0.05% |
| Frequency Response | 10 Hz - 100 kHz (+1, -3 dB) |
| Signal-to-Noise Ratio | 110 dB |
| Input Sensitivity | 200 mV |
| Input Impedance | 47 k ohms |
| HDMI Version | 1.3a |
| Audio Formats Supported | Dolby TrueHD, DTS-HD Master Audio |
| THX Certified | Yes (THX Ultra2 Plus) |
| DTS | DTS Neo:6 |
| Video Upscaling | Yes (up to 1080p) |
| Video Inputs | Component x 3 |
| Video Outputs | 1 x Component, 1 x Composite |
| Power Output | 150W per channel (8 ohms, 20Hz-20kHz, 0.05% THD) |
To Next Page
