Denon AVR-1602

7
8
(Remote cotltrol unit/
(Remote cot_trol unit/
Use the [[_) (left) and (_ (right) buttons to set the D COMR
(Initial)
L._==L..UE=H""== UE" E" r_ r_
(left) button (right) button
NOTE:
Press the SELECT or C]D (down) button to switch to the LFE setting This parameter is not displayed
during DTS playback.
(Remote cotltrol unit/
Use the E_D (left) and _ (right) buttons to set the LFE level
• The level can be adjusted in units of 1 dB from -10 to 0 dB
(The level can be adjusted I dB at a time from 0 dB to +10 dB during DTS play)
Set to the desired level according to the speaker systems being used and the source to be played
Press the SELECT or C]D (down} button to switch to the default setting
(Remote cot_trol unit)
(Remote cotltrol unit/
To reset the settings to the factory defaults, use the _ (left) and _ (right) buttons to display "Yes".
[E:,Ei:FnuLrV H ]
(left) button (right) button
Press the SELECT or (_D (down} button to switch to the DCOMR setting.
(Remote cot_trol unit)
NOTE:
• When making parameter settings, the display will return to the regular condition several seconds after the last button was pressed and the
setting will be completed
Surround parameters _2_
D.COMP. (Dynamic Range Compression):
Motion picture soundtracks have tremendous dynamic range (the contrast between very soft and very loud sounds) For listening late at night,
or whenever the maximum sound level is lower than usual, the Dynamic Range Compression allows you to hear all of the sounds in the
soundtrack (but with reduced dynamic range) (This only works when playing program sources recorded in Dolby Digital.) Select one of the four
parameters ("OFF", "LOW", "MID" (middle} or "HI" (high)) Set to OFF for normal listening
LFE (Low Frequency Effect}:
Program source and adjustment range
1. Dolby Digital: -10 dB to 0 dB
2. DTS Surround: 0 dB to +10 dB
"_ When Dolby Digital encoded software is played, it is recommended that the LFE LEVEL be set to 0 dB for correct Dolby Digital
playback.
When DTS encoded movie software is played, it is recommended that the LFE LEVEL be set to 0 dB for correct DTS playback.
-_ When DTS encoded music software is played, it is recommended that the LFE LEVEL be set to -10 dB for correct DTS playback.
33