EasyManuals Logo

Denon AVR-5308CI User Manual

Denon AVR-5308CI
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
b If the access points are not detected automatically, use i to
select the “Manual” and press ENTER.
Setting becomes manual. For details, see “Manual settings”
(vpage 35, 36).
b If the access points are repeat search, use i to select the
“Search” and press ENTER.
e If there is an encryption setting for the access point you selected
in step w, enter same encryption key as used for the access
point. (If there is no encryption setting, proceed to step t.
1
Fitting a rod antenna (vpage 20).
b If a LAN cable is connected, remove it.
2
Turn on the AVC-A1HD (vpage 54).
3
Set the access point at the GUI menu “Manual Setup”
– “Network Setup” – “Network Setup”.
When searching access points to connect automatically, refer to
“Automatic settings”.
When searching access points to connect manually, refer to
“Manual settings”.
n Automatic settings
q Select “Search” and press ENTER.
The access point you have set is displayed.
w Use ui to select the access point, and then press
ENTER.
Setup
e Use ui p to input the address and press ENTER.
IP Address
:
Set the IP address within the ranges shown below. The Network
Audio function cannot be used if other IP addresses are set.
CLASS A: 10.0.0.0 ~ 10.255.255.255
CLASS B: 172.16.0.0 ~ 172.31.255.255
CLASS C: 192.168.0.0 ~ 192.168.255.255
Subnet Mask
:
When connecting an xDSL modem or terminal adapter directly
to the AVC-A1HD, input the subnet mask indicated in the
documentation supplied by your provider. Normally input
255.255.255.0.
Default Gateway
:
When connected to a gateway (router), input its IP address.
Primary DNS
Secondary DNS
:
If there is only one DNS address indicated in the documentation
supplied by your provider, input it at “Primary DNS”. If there are
two or more DNS addresses, input the first one at “Secondary
DNS”.
r Use i to select “Exit” and press
ENTER.
Setup is complete.
b When connecting to the network via a Proxy server, select “Proxy”
and press ENTER (vpage 36 “Proxy settings”).
Select when searching
access points again.
Wireless LAN settings
Use this procedure to configure the Wireless LAN settings.
w Select the access point.
Example) DENON
Select when access
points cannot be searched
automatically.
q Select “Search”.
r Set only during
“WEP” in step w.
t Select “Connection”.
e Enter
encryption key.

Table of Contents

Other manuals for Denon AVR-5308CI

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-5308CI and is the answer not in the manual?

Denon AVR-5308CI Specifications

General IconGeneral
BrandDenon
ModelAVR-5308CI
CategoryAmplifier
LanguageEnglish

Related product manuals