A
aprilmendezSep 5, 2025
What to do if Denon AVR-589 does not operate properly?
- CCharles MorrisSep 5, 2025
If the Denon Stereo Receiver is not operating properly, reset the microprocessor.
To Next PageTo Next PageWhat to do if Denon AVR-589 does not operate properly?
If the Denon Stereo Receiver is not operating properly, reset the microprocessor.
What to do if no sound is produced from subwoofer on Denon Stereo Receiver?
If there's no sound from the subwoofer, ensure the subwoofer's power is on. Check that the “Subwoofer” setting at “Speaker Setup” is set to “Yes”. Verify the subwoofer is properly connected and adjust its volume to an appropriate level.
What to do if there is no sound from center speaker on Denon AVR-589?
If no sound is coming from the center speaker, and you are playing a monaural source (TV, AM radio broadcast, etc.) in “STANDARD” (Dolby/ DTS Surround) mode, change the mode to something other than “STANDARD” (Dolby/ DTS Surround).
How to fix no HDMI audio signals from Denon AVR-589 Stereo Receiver speakers?
The audio signal input to the HDMI input connector cannot be played on the AVR-589. Input the audio signal to the digital audio input connector or analog audio input connector.
Why is there no sound from surround speakers on my Denon Stereo Receiver?
If no sound is produced from the surround speakers, and the surround mode is set to “STEREO” or “DIRECT”, set the receiver to a surround playback mode.
What to do if no sound from monitor connected with HDMI connections on Denon Stereo Receiver?
If no sound is output from the monitor connected with HDMI connections, check the HDMI input setting.
What to do if Denon AVR-589 Stereo Receiver display is off?
If the display is off, the Dimmer setting is set to “OFF”. Set to something other than “OFF}.
How to fix Denon AVR-589 power that does not turn on?
If the Denon Stereo Receiver power does not turn on, check the power cord plug to ensure it is properly inserted.
Why does my Denon AVR-589 Stereo Receiver keep turning off?
The Denon Stereo Receiver may be turning off due to the protection circuit being activated by a temperature rise in the unit's internal parts. Immediately switch off the power, and re-apply it after the body temperature has sufficiently cooled. Re-install the unit in a location with good ventilation.
Why does Denon AVR-589 Stereo Receiver power switch off suddenly?
The Denon Stereo Receiver may suddenly switch off if speakers have impedance lower than specified, or if speaker cable core wires touch each other or the AVR-589 rear panel. To resolve this, use speakers with the specified impedance. Unplug the power cord, twist the core wires together tightly or effect termination treatments, and then reconnect.
General| Input Sensitivity | 200 mV |
|---|---|
| HDMI Switching | Yes |
| Frequency Response | 10Hz-100kHz |
| Inputs | 4 x composite |
| Outputs | 1 x HDMI |
| Input Impedance | 47 kΩ |
| Tuner Type | Digital |
| Tuner Bands | AM/FM |
| Audio D/A Converter | 192 kHz/24-bit |
| Tuner Frequency Range | FM: 87.5 - 108 MHz |
| Dimensions (W x H x D) | 434 x 171 x 377 mm |
