3
Select the play mode.
Press the SURROUND MODE button, then turn the SELECT
knob.
Example: Stereo
IMar uwtl Fkmote conirol unItI
% To select the surround mode while adjusting
s”FlKNJND MOE
the surround parameters, channel volume or
tone control, press the surround mode
button then operate the selector.
(See page 34.)
%
(Man unft)
Input mode display
l In the AUTO mode
- ,NP”T ~
A”p Pm+ DTS
;$f:
0 0
l In the DIGITAL PCM mode
~ ,NP”T ~
A”C
m*
0
-;s
0
l In the DIGITAL DTS mode
,NPLl
A”K Pa.4
0
0
-g
l In the ANALOG mode
INPLn ~
A”TO PO.4 ms
0
0 0
One of these lights, depending on the
Input signal
~DIGITAL~
piziiq
jliiziq
piiiaq
4
Start playback on the selected component.
l For operating instructions, refer to the component’s
manual.
The volume level IS
dIsplayed o” the
mas&zr volume level
djsplay
% The volume can be adjusted within the range of -70 to 0 to 18 dB,
in steps of 1 dB. However, when the channel level is set as
described on page 34, if the volume for any channel is set at +I dB
or greater, the volume cannot be adjusted up to 18 dB. (In this case
the maximum volume is adjusted to “I 8 dB - (Maximum value of
channel level)“.)
% The m indicator lights when digital signals are being input
properly. If the 1-1 indicator does not light, check whether
the digital Input component setup (page 21) and connections are
correct and whether the component’s power is turned on.
Input mode when playing DTS sources
l Noise will be output ;f DTS-compatfble CDs or LDs are played in the
“ANALOG” or “PCM” mode.
When playing DTS-compatible sources, be sure to connect the
source component to the dIgital input jacks (OPTICAL/COAXIAL)
and set the input mode to “DTS”.
NOTE:
l The -1 indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound will be
heard.
III Adjusting the sound quality (tone)
1
The tone switches as follows each time the TONE CONTROL
button is pressed,
BASS - TREBLE
2
With the name of the volume to be SELECT
adjusted selected, turn the SELECT
knob to adjust the level.
401
(Mann unItI
l To increase the bass or treble: Turn the control clockwise.
(The bass or treble sound can be increased to up to +I2 dB
in steps of 2 dB.1
l To decrease the bass or treble: Turn the control
counterclockwise. (The bass or treble sound can be
decreased to up to -12 d6 in steps of 2 dB.)
3
If you do not want the bass and treble to be adjusted, turn on
the tone defeat mode.
TONE DEFEAT
%
% The signals do not pass through the
bass and treble adjustment circuits,
so it provides higher quality sound.
31
To Next Page
Loading...
Need help?
General
