[21 Listening over headphones
I
Plug the headphones’ plug into the
jack.
PHONES
NOTE:
To prevent hearing loss, do not raise the volume level excessively
when using headphones.
% Connect the headphones to the
PHONES jack.
The pre-out output (including the
speaker output) is automatically
1
turned off when headphones are
connected.
131 Turning the sound off temporarily (muting)
Use this to turn off the audio output
temporarily.
Press the MUTING button,
% Cancelling MUTING mode.
l Press the MUTING button again.
l Muting will also be cancelled
when MASTER VOL IS adjusted
up or down.
141 Combining the currently playing sound with the desired image
1
Simulcast playback
Use this switch to monitor a
“IDE0 SEU
video source other than the
audio source.
Press the VIDEO SELECT
button repeatedly until the
desired source appears on
the display.
% Cancelling simulcast playback.
l Select “SOURCE” using the video select button.
l Switch the program source to the component
connected to the video input jacks.
El
Checking the currently playing program source, etc.
1
Front panel display
l Descriptrons of the unit’s
operations
are also
SAWS
STAT”S
displayed on the front
panel display. In addition,
the display
can be
switched to check the
q--J Dsi$)
unit’s operating status
(Mm unit)
Remote control un~tl
while playing a source by
pressing the STATUS
button.
Using the dimmer function
l Use this to change the
DIMMER
m.NvlER
brightness of the display.
The display brightness
changes in four steps
% F
(bright, medium, drm and
IMaw mtl
Remote control unit1
off) by pressing the main
unit’s DIMMER button
repeatedly.
BRIGHT - MEDIUM - DIM
t--- OFF 1
32
To Next Page
Loading...
Need help?
General
