22
ENGLISH
8
Press the ENTER button to finish surround
parameter mode.
(Remote control unit)
NOTE:
• When making parameter settings, the display
will return to the regular condition several
seconds after the last button was pressed and
the setting will be completed.
6
Set the surround parameters according to the
mode.
(Main unit) (Remote control unit)
• The mode switches as shown below each
time the button is pressed.
MODE Dolby PL
CINEMA EQ
TONE DEFEAT
DEFAULT
MODE CINEMA
CINEMA EQ
TONE DEFEAT
DEFAULT
MODE MUSIC
PANORAMA
DIMENSION
CENTER WIDTH
DEFAULT
TONE DEFEAT
SURROUND BACK
SURROUND BACK
SURROUND BACK
If you do want the bass and trable to be
adjusted, turn off the tone defeat mode.
7
Set the various surround parameters.
• CINEMA EQ setting
ON OFF
or or
CINEMA EQ OFF
• PANORAMA setting
• DIMENSION setting
• CENTER WIDTH setting
• TONE DEFEAT setting
• DEFAULT setting
YES Y/N NO
or or
DEFAULT Y/N
• SURROUND BACK SPEAKER setting
Select “Yes” to reset to the factory defaults.
DTS NEO:6 mode
1
Select the function to which the component you
want to play is connected.
Example: DVD
(Main unit) (Remote control unit)
2
Select the DTS NEO:6 mode.
(Main unit) (Remote control unit)
3
Play a program source.
• The mode switches as shown below each
time the button is pressed.
DOLBY PLII cinema
DTS NEO:6
The DTS NEO:6 Cinema or
Music mode can be chosen
directly by pressing the
CINEMA or MUSIC button
on the remote control unit
during playback in the DTS
NEO:6 mode.
4
Select the surround parameter mode.
MODE cinema
Display
(Main unit) (Remote control unit)
To perform this operation from the remote
control unit, check that the mode selector
switch is set to “AUDIO”.
5
Select the optimum mode for the source.
(Main unit) (Remote control unit)
or or
MODE musicMODE cinema
To Next Page
Loading...
Need help?
General
