Advanced Operation Advanced Operation
ENGLISH
36
ENGLISH
When the ZONE2 SOURCE function is set to
“TUNER”, the preset channel can be selected pressing
[CHANNEL].
Press [INPUT SELECTOR].
The ZONE2 source switches directly.
The output level of the ZONE2 SPEAKER OUT
terminals can be controlled pressing [VOLUME].
Default setting (ZONE2 volume level):
– – – dB (Minimum)
4
5
6
Set [MODE SELECTOR 1] to the “AUDIO”.
Press [ZONE2 ON].
• The ZONE2 indicator lights.
To cancel the ZONE2 mode:
Press [ZONE2 OFF].
1
3
Remote control unit operations during multi-
source playback (selecting the source)
This is only possible when the main unit in the ZONE2 mode (
page 43).
Set [MODE SELECTOR 2] to the “ZONE2”.
2
Multi zone music entertainment system
• ZONE2 speaker out can be used when “ZONE2” is selected at “Power Amp Assignment”. In this case, surround back speaker out cannot
be used for MAIN ZONE.
• For instructions on installation and operation of separately sold devices, refer to the devices’ operating instructions.
• The main zone output can be turned on and off with [MAIN].
¢ When using the SURR.BACK/ZONE2 amplifier as the ZONE2
•To use the ZONE2, turn on the ZONE2.
•The output of the ZONE2 SPEAKER OUT terminals can be adjusted with [ZONE2 VOLUME].
• The input source selected with [INPUT SELECTOR] is output for the ZONE2 speaker output.
[System configuration and connections example]
Using this unit’s internal amplifier as the ZONE2.
To Next Page
Loading...
Need help?
General
