347
AVR-1708/1508/688/588/488 AVC-1508
é
ç·ćłă«ă€ăăŠ
zîîć°ăźéšćăŻćźć
šăç¶æăăăăă«éèŠăȘéšćă§ăă
ćŸăŁăŠäș€ææăŻćż
ăæćźăźéšćăäœżçšăăŠăă ăăă
æłšïŒ
(1) æćźăȘăæ”æć€ăŻ Î©ăïœ ăŻ ïœÎ©ăM 㯠MΩ ăç€ș
ăă
(2) æćźăȘăăłăłăăłă”ăŒăźć€ăŻ Â”Făïœ ăŻ ïœF ăç€șăă
(3) ćéšăźé»ć§ăŻçĄäżĄć·ăźć€ăç€șăă
ăăźé
ç·ćłăŻćșæŹé
ç·ćłă§ăăæčèŻçăźăă〿Žăăăăš
ăăăăŸăăźă§ăäșæżăă ăăă
NOTE FOR SCHEMATIC DIAGRAM
WARNING:
Parts marked with this symbol z have critical characteristics.
Use ONLY replacement parts recommended by the manufac-
turer.
CAUTION:
Before returning the unit to the customer, make sure you
make either (1) a leakage current check or (2) a line to chas-
sis resistance check. If the leakage current exceeds 0.5 milli-
amps, or if the resistance from chassis to either side of the
power cord is less than 460 kohms, the unit is defective.
WARNING:
DO NOT return the unit to the customer until the problem is
located and corrected.
NOTICE:
ALL RESISTANCE VALUES IN OHM. k=1,000 OHM
M=1,000,000 OHM
ALL CAPACITANCE VALUES IN MICRO FARAD.
P=MICRO-MICRO FARAD
EACH VOLTAGE AND CURRENT ARE MEASURED AT
NO SIGNAL INPUT CONDITION.
CIRCUIT AND PARTS ARE SUBJECT TO CHANGE
WITHOUT PRIOR NOTICE.