Denon AVR-770SD - Surround Mode Optimization and DTS NEO:6; Optimizing Source Mode Selection; DTS NEO:6 Mode Configuration

25
ENGLISH
5
Select the optimum mode for the source.
(Remote control unit)
6
Select the various parameters. (See “Surround
parameters q” for a description of the various
parameters.)
(Remote control unit)
MODE musicMODE cinemaMODE DOLBY PL
7
Set the various surround parameters.
(Remote control unit)
8
Press the SURROUND PARAMETER button to
finish surround parameter mode.
(Remote control unit)
MASTER VOLUME
PHONES
TONE CONTROL TUNING STATUS SURROUND MODE
DOLBY/DTS
SURROUND
BAND
AV SURROUND RECEIVER AVR-770SD
AUTO
PCM
INPUT MODE
FUNCTION / SELECT
SIGNAL DETECT
SURROUND BACK
OUTPUT
DIRECT
/STEREO
5ch/6ch
STEREO
DVD
AUTO
DIG
DIGITAL
STANDBY
¢ON / STANDBY
£OFF
1
2
5, 7
2
1
6
4, 8
6
5, 7
DTS NEO:6 mode
1
Select the function to which the component
you want to play is connected.
Example: DVD
FUNCTION / SELECT
(Main unit) (Remote control unit)
2
Select the DTS NEO:6 mode.
DOLBY/DTS
SURROUND
(Main unit) (Remote control unit)
3
Play a program source.
• The mode switches as shown below each
time the button is pressed.
DOLBY PLII DTS NEO:6
The DTS NEO:6 Cinema or
Music mode can be chosen
directly by pressing the
CINEMA or MUSIC button
on the remote control unit
during playback in the DTS
NEO:6 mode.
4
Select the surround parameter mode.
(Remote control unit)
To perform this operation from the remote
control unit, check that the mode selector
switch is set to “AUDIO”.
5
Select the optimum mode for the source.
(Remote control unit)
6
Select the various parameters.
(Remote control unit)
MODE musicMODE cinema
Display
MODE cinma