35
ENGLISH
TP search
Use this function to find RDS stations broadcasting traffic program (TP stations).
1
Set the input function to
“TUNER”.
(Remote control unit)
3
Press the CHANNEL + (up)
or – (down) button TP search
begins.
(Remote control unit)
2
Press the RDS button until
“TP SEARCH” appears on
the display.
(Remote control unit)
If no TP station is found with above operation,
all the reception bands are searched.
4
The station name is displayed on the display
after searching stops.
5
To continue searching, repeat step 3.
If no other TP station is found when all the
frequencies are searched, “NO PROGRAMME”
is displayed.
The main unit’s display switches as follows
each time the RDS buttons are pressed.
RDS SEARCH PTY SEARCH
RT ON TP SEARCH
Display
This is the screen when operated.
This is the screen when operated.
NOTES:
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the button settings are reset to the default values (the values set
upon shipment from the factory).
MASTER VOLUME
PHONES
TONE CONTROL
TUNING
STATUS
SURROUND MODE
DOLBY/DTS
SURROUND
BAND
AV SURROUND RECEIVER AVR-770SD
AUTO
PCM
INPUT MODE
FUNCTION / SELECT
SIGNAL DETECT
SURROUND BACK
OUTPUT
DIRECT
/STEREO
5ch/6ch
STEREO
DVD
AUTO
DIG
DIGITAL
STANDBY
¢ON / STANDBY
£OFF
1
2 2
17
INITIALIZATION OF THE MICROPROCESSOR
When the indication of the display is not normal or when the operation of the unit does not shows the reasonable
result, the initialization of the microprocessor is required by the following procedure.
1
Switch off the unit using the main unit’s power
operation switch.
2
Hold the following 5CH/6CH STEREO button
and DIRECT/STEREO button, and turn the main
unit’s power operation switch on.
3
Check that the entire display is flashing with an
interval of about 1 second, and release your
fingers from the 2 buttons and the
microprocessor will be initialized.
Turning on the main unit’s power from the standby mode without using the remote control unit
• Press the power switch on the main unit while pressing the 5CH/6CH STEREO button on the main unit’s
panel to turn on the power.
16
LAST FUNCTION MEMORY
• This unit is equipped with a last function memory which stores the input and output setting conditions as they
were immediately before the power is switched off.
This function eliminates the need to perform complicated resettings when the power is switched on.
• The unit is also equipped with a back-up memory. This function provides approximately one week of memory
storage when the main unit’s power switch is off and with the power cord disconnected.
RT (Radio Text)
“RT” appears on the display when radio text data is
received.
When the RDS button is pressed until “RT” appears
on the display while receiving an RDS broadcast
station, the text data broadcast from the station is
displayed. To turn the display off, use the 0 and 1
cursor buttons on the remote control unit.
This is the screen when operated.
To Next Page
Loading...
Need help?
General
