EasyManua.ls Logo

Denon AVR-770SD

Denon AVR-770SD
288 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
32
15
LISTENING TO THE RADIO
Auto tuning
MASTER VOLUME
PHONES
TONE CONTROL
TUNING
STATUS
SURROUND MODE
DOLBY/DTS
SURROUND
BAND
AV SURROUND RECEIVER AVR-770SD
AUTO
PCM
INPUT MODE
FUNCTION / SELECT
SIGNAL DETECT
SURROUND BACK
OUTPUT
DIRECT
/STEREO
5ch/6ch
STEREO
DVD
AUTO
DIG
DIGITAL
STANDBY
¢ON / STANDBY
£OFF
1
23
3
Press the TUNING + or button.
Automatic searching begins, then stops
when a station is tuned in.
1
3
2
NOTE:
When in the auto tuning mode on the FM band, the STEREO indicator lights on the display when a stereo
broadcast is tuned in. At open frequencies, the noise is muted and the TUNED and STEREO indicators
turn off.
Manual tuning
1
Set the input function to TUNER.
3
Press the BAND button to set the manual
tuning mode.
Check that the displays AUTO indicator
turns off.
4
Press the TUNING + or button to tune in the
desired station.
The frequency changes continuously when the
button is held in.
2
Watching the display, press the BAND button
to select the desired band (AM or FM).
NOTE:
When the manual tuning mode is set, FM stereo broadcasts are received in monaural and the STEREO
indicator turns off.
1
Set the input source to TUNER.
2
Watching the display, press the BAND button
to select the desired band (AM or FM) and to
set the auto tuning mode.
FUNCTION / SELECT
BAND
(Main unit) (Remote control unit)
(Main unit) (Remote control unit)
(Remote control unit)
ENGLISH
TUNING
(Main unit)
Preset stations
Preparations:
Use the Auto tuning or Manual tuning operation
to tune in the station to be preset in the memory.
1
Press the MEMORY button.
2
Press the SHIFT button and
select the desired memory
block (A to E).
4
Press the MEMORY button
again to store the station in
the preset memory.
To preset other channels, repeat steps 1 to 4.
A total of 40 broadcast stations can be preset 8
stations (channels 1 to 8) in each of blocks A to E.
3
Press the CHANNEL + or
button to select the desired
preset channel (1 to 8).
NOTE:
Please make sure the AUDIO position of
the slide switch on the remote control unit.
1,4
3
2
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
A1 FM 87.50M
Display
Lit

Table of Contents

Related product manuals