o
Adjusting the interval time of macro
operations transmitting
The macro operation transmission interval can be adjusted.
0
The default setting is “0.50”.
1
Press and hold RC SETUP for more than 3 seconds.
“SETUP” and p indicator flashes twice on the remote control unit.
2
Use ui to display “MACRO” on the remote control unit
and press ENTER.
3
Use ui to display “MAN” on the remote control unit
and press ENTER.
4
When “MCNo” appears on the remote control unit,
press the MACRO A – D button that you want to set.
5
Press RC SETUP.
6
Use ui to set the macro operation transmission
interval and press ENTER.
“OK” flashes four times on the remote control unit and the normal
operation mode is restored.
Remote control unit
display
Time values that you can set
0.25 0.25 sec
0.50 0.5 sec
0.75 0.75 sec
1.00 1 sec
1.25 1.25 sec
Contents Connections Playback Settings Tips Appendix
291
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
