Advanced Setup
Set advanced settings relating to speakers.
o
Subwoofer Output
n
Subwoofer Output
Selects which low frequency signals are sent to the subwoofer outputs.
LFE
(Default):
The subwoofer outputs receive the LFE
track, plus any redirected bass from
speakers with crossovers set. Use this
setting as the default for home theater
bass management in a typical room.
LFE+Main:
The subwoofer outputs receive the LFE
track, plus redirected bass, and a copy of
the low frequency signals from all full
band speakers.
0
“Subwoofer Output” can be set when “Speaker Layout” - “Subwoofer” in the
menu is set to “Yes”. (v p. 94)
0
Play music or a movie source and select the mode offering the strongest bass.
0
If “Crossovers” - “Front” and “Center” are set to “Full Band”, and “Subwoofer
Output” is set to “LFE”, no sound may be output from the subwoofers,
depending on the input signal or selected sound mode. (v p. 94)
Select “LFE+Main” if you want the bass signals to always be produced from
the subwoofer.
n
Bass Extraction LPF
Set the low pass filter for the bass to be copied from the Full Band
Speaker for each speaker when “Subwoofer Output” is “LFE+Main”.
40 Hz / 60 Hz / 80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz /
180 Hz / 200 Hz / 250 Hz (Default : 80 Hz)
0
Setting can only be performed for speakers for which “Crossovers” is set to
“Full Band”.
o
LPF for LFE
Selects the crossover point for the LFE channel. Set this when you
want to change the playback frequency (low pass filter point) of the
subwoofer.
80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz/ 150 Hz / 180 Hz /
200 Hz / 250 Hz (Default: 100 Hz)
Contents Connections Playback Settings Tips Appendix
97
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
