EasyManuals Logo

Denon AVR-S910W Owner's Manual

Denon AVR-S910W
296 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #203 background imageLoading...
Page #203 background image
o
Dolby Speaker Setup
Set the distance between the Dolby Atmos Enabled speaker and the
ceiling.
3.0 ft - 11.0 ft / 0.90 m - 3.30 m(Default : 6.0 ft / 1.80 m)
0
This can be set when “Front Dolby” or “Surround Dolby” is set to “Large” or
“Small” in “Speaker Config.”.
o
Set Defaults
The “Distances” settings are returned to the default settings.
Levels
Set the volume of the test tone to be the same at the listening position
when it is output from each speaker.
o
Test Tone Start
A test tone is output from the selected speaker.
While listening to the test tone, adjust the volume output from the
selected speaker.
–12.0 dB – +12.0 dB (Default : 0.0 dB)
0
The set “Levels” are reflected in all sound modes.
0
If you wish to adjust the channel level for each input source, carry out the
settings in “Channel Level Adjust”. (v
p. 118)
0
When headphones are connected to the PHONES connector on this unit, you
cannot set “Levels”.
o
Set Defaults
The “Levels” settings are returned to the default settings.
Contents
Connections Playback Settings Tips Appendix
203
Front panel Display Rear panel Remote Index

Table of Contents

Other manuals for Denon AVR-S910W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-S910W and is the answer not in the manual?

Denon AVR-S910W Specifications

General IconGeneral
Receiver typeSurround
Audio output channels7.2 channels
Power output per channel (1KHz@6 Ohm)185 W
Power output per channel (20-20KHz@8 Ohm)- W
HDMI in8
Composite video in2
Digital audio coaxial in1
Wi-FiYes
AM band range520 - 1710 kHz
FM band range87.5 - 107.9 MHz
Supported radio bandsAM, FM
Internet radio services supportedPandora, SIRIUS Internet Radio, Spotify
Optical drive includedNo
Display-
Product colorBlack
Audio decodersDolby Surround, Dolby TrueHD
AC input voltage120 V
Power consumption (standby)0.1 W
Power consumption (typical)500 W
Audio formats supportedAAC, ALAC, FLAC, MP3, WAV, WMA
Weight and Dimensions IconWeight and Dimensions
Depth337.82 mm
Width434.34 mm
Height167.64 mm
Weight9389 g

Related product manuals