Denon AVR-S910W Owner's Manual

o
Desired sound does not come out
Symptom Cause / Solution Page
The volume does not
increase.
0
The maximum volume is set too low. Set the maximum volume using “Limit” on the menu.
161
0
Appropriate volume correction processing is performed according to the input audio format and settings,
so the volume may not reach the upper limit.
－
No sound comes out with
the HDMI connection.
0
Check the connection of the HDMI connectors.
50
0
When outputting HDMI audio from the speakers, set “HDMI Audio Out” on the menu to “AVR”. To output
from the TV, set “TV”.
170
0
When using the HDMI control function, check that the audio output is set to the AV amplifier on the TV.
135
No sound comes out of a
specific speaker.
0
Check that speaker cables are properly connected.
－
0
Check that a selection other than “None” is set for the “Speaker Config.” setting in menu.
197
0
Check the “Assign Mode” setting in the menu.
196
0
When the sound mode is “Stereo” and “Virtual”, audio is only output from the front speakers and
subwoofer.
－
No sound is produced from
subwoofer.
0
Check the subwoofer connections.
－
0
Turn on the subwoofer’s power.
－
0
Set “Speaker Config.” – “Subwoofer” on the menu to “Yes”.
198
0
When “Speaker Config.” - “Front” in the menu is set to “Large”, depending on the input signal and the
sound mode, no sound may be output from the subwoofer.
198
0
When no subwoofer audio signal (LFE) is included in the input signals, no sound may be output from the
subwoofer.
205
0
You can make the subwoofer always output sound by setting the “Subwoofer Mode” to “LFE+Main”.
205
DTS sound is not output.
0
Check that the digital audio output setting on the connected device is set to “DTS”.
－
0
Set “Decode Mode” on the menu to “Auto” or “DTS”.
185
Dolby Atmos, Dolby
TrueHD, DTS-HD, Dolby
Digital Plus audio is not
output.
0
Make HDMI connections.
54
0
Check the digital audio output setting on the connected device. On some devices, “PCM” is set by default.
－
Contents Connections Playback Settings Tips Appendix
236
Front panel Display Rear panel Remote Index

Denon AVR-S910W Specifications

General

Receiver type	Surround
Audio output channels	7.2 channels
Power output per channel (1KHz@6 Ohm)	185 W
Power output per channel (20-20KHz@8 Ohm)	- W
HDMI in	8
Composite video in	2
Digital audio coaxial in	1
Wi-Fi	Yes
AM band range	520 - 1710 kHz
FM band range	87.5 - 107.9 MHz
Supported radio bands	AM, FM
Internet radio services supported	Pandora, SIRIUS Internet Radio, Spotify
Optical drive included	No
Display	-
Product color	Black
Audio decoders	Dolby Surround, Dolby TrueHD
AC input voltage	120 V
Power consumption (standby)	0.1 W
Power consumption (typical)	500 W
Audio formats supported	AAC, ALAC, FLAC, MP3, WAV, WMA

Weight and Dimensions

Depth	337.82 mm
Width	434.34 mm
Height	167.64 mm
Weight	9389 g