EasyManuals Logo

Denon AVR-X1200W User Manual

Denon AVR-X1200W
277 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #184 background imageLoading...
Page #184 background image
Error messages
An error message is displayed if Audyssey
®
Setup could not be completed due to speaker placement, the measurement environment, etc. If an error
message is displayed, check the relevant items and perform the necessary measures. Be sure to turn off the power before checking speaker connections.
Examples Error details Measures
No speakers found.
0
Sound calibration microphone is not
detected.
0
Connect the included Sound calibration microphone to the
SETUP MIC jack of this unit.
0
Not all speakers could be detected.
0
Check the speaker connections.
Ambient noise is too high or level is too
low
0
There is too much noise in the room.
0
Either turn off any device generating noise or move it away.
0
Perform again when the surroundings are quieter.
0
Speaker or subwoofer sound is too low.
0
Check the speaker installation and the direction in which the
speakers are facing.
0
Adjust the subwoofer’s volume.
Front R : None
0
The displayed speaker could not be
detected.
0
Check the connections of the displayed speaker.
Front R : Phase
0
The displayed speaker is connected with the
polarity reversed.
0
Check the polarity of the displayed speaker.
0
For some speakers, this error message may be displayed
even if the speaker is properly connected. If you are sure the
connection is correct, press p to select “Ignore”, then press
ENTER.
Contents Connections Playback Settings Tips Appendix
184
Front panel Display Rear panel Remote Index

Table of Contents

Other manuals for Denon AVR-X1200W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X1200W and is the answer not in the manual?

Denon AVR-X1200W Specifications

General IconGeneral
HDMI in6
AC (power) inYes
Composite video in2
USB ports quantity1
Digital audio coaxial in0
Receiver type-
Audio output channels7.2 channels
Total Harmonic Distortion (THD)1 %
Power output per channel (20-20KHz@8 Ohm)145 W
FM band range87.5 - 108 MHz
Supported radio bandsAM, FM
Internet radio services supportedSpotify
Product colorBlack
Audio decodersDTS-HD Master Audio
Apple docking compatibilityiPhone, iPod
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)0.5 W
Power consumption (typical)430 W
Connectivity technologyWired
Optical drive includedNo
Audio formats supportedAIFF, ALAC, FLAC
Weight and Dimensions IconWeight and Dimensions
Depth339 mm
Width434 mm
Height151 mm
Weight8500 g

Related product manuals