Denon AVR-X1200W User Manual

o
Desired sound does not come out
Symptom Cause / Solution Page
The volume does not
increase.
0
The maximum volume is set too low. Set the maximum volume using “Limit” on the menu.
157
0
Appropriate volume correction processing is performed according to the input audio format and settings,
so the volume may not reach the upper limit.
－
No sound comes out with
the HDMI connection.
0
Check the connection of the HDMI connectors.
48
0
When outputting HDMI audio from the speakers, set “HDMI Audio Out” on the menu to “AVR”. To output
from the TV, set “TV”.
164
0
When using the HDMI control function, check that the audio output is set to the AV amplifier on the TV.
131
No sound comes out of a
specific speaker.
0
Check that speaker cables are properly connected.
－
0
Check that a selection other than “None” is set for the “Speaker Config.” setting in menu.
187
0
Check the “Assign Mode” setting in the menu.
186
0
When the sound mode is “Stereo” and “Virtual”, audio is only output from the front speakers and
subwoofer.
－
No sound is produced from
subwoofer.
0
Check the subwoofer connections.
－
0
Turn on the subwoofer’s power.
－
0
Set “Speaker Config.” – “Subwoofer” on the menu to “Yes”.
188
0
When “Speaker Config.” - “Front” in the menu is set to “Large”, depending on the input signal and the
sound mode, no sound may be output from the subwoofer.
187
0
When no subwoofer audio signal (LFE) is included in the input signals, no sound may be output from the
subwoofer.
195
0
You can make the subwoofer always output sound by setting the “Subwoofer Mode” to “LFE+Main”.
195
DTS sound is not output.
0
Check that the digital audio output setting on the connected device is set to “DTS”.
－
0
Set “Decode Mode” on the menu to “Auto” or “DTS”.
174
Dolby Atmos, Dolby
TrueHD, DTS-HD, Dolby
Digital Plus audio is not
output.
0
Make HDMI connections.
52
0
Check the digital audio output setting on the connected device. On some devices, “PCM” is set by default.
－
Contents Connections Playback Settings Tips Appendix
223
Front panel Display Rear panel Remote Index

Denon AVR-X1200W Specifications

General

HDMI in	6
AC (power) in	Yes
Composite video in	2
USB ports quantity	1
Digital audio coaxial in	0
Receiver type	-
Audio output channels	7.2 channels
Total Harmonic Distortion (THD)	1 %
Power output per channel (20-20KHz@8 Ohm)	145 W
FM band range	87.5 - 108 MHz
Supported radio bands	AM, FM
Internet radio services supported	Spotify
Product color	Black
Audio decoders	DTS-HD Master Audio
Apple docking compatibility	iPhone, iPod
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0.5 W
Power consumption (typical)	430 W
Connectivity technology	Wired
Optical drive included	No
Audio formats supported	AIFF, ALAC, FLAC

Weight and Dimensions

Depth	339 mm
Width	434 mm
Height	151 mm
Weight	8500 g