EasyManuals Logo

Denon AVR-X250BT User Manual

Denon AVR-X250BT
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #88 background imageLoading...
Page #88 background image
o
Pow.On Default
Set the mode to ECO when the power is on.
Last
(Default):
The ECO Mode will be set to the previous
setting before the power was switched
off.
On:
When power is turned on, the mode will
always be switched to the “ECO Mode” in
“On”.
Auto:
When power is turned on, the mode will
always be switched to the “ECO Mode” in
“Auto”.
Off:
When power is turned on, the mode will
always be switched to the “ECO Mode” in
“Off”.
o
Auto Standby
Set so the unit power automatically switches to standby.
Sets the time for switching to auto standby when there are no audio or
video signals input into this unit.
Before the unit enters standby mode, “Auto Standby” is displayed on
the unit display and the menu screen.
60 min:
The unit goes into standby after 60 minutes.
30 min:
The unit goes into standby after 30 minutes.
15 min
(Default):
The unit goes into standby after 15 minutes.
Off:
The unit does not go into standby
automatically.
Contents Connections Playback Settings Tips Appendix
88
Front panel Display Rear panel Remote Index

Table of Contents

Other manuals for Denon AVR-X250BT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X250BT and is the answer not in the manual?

Denon AVR-X250BT Specifications

General IconGeneral
Impedance16 Ω
Receiver typeSurround
Frequency range10 - 100000 Hz
Pre-out connectivityYes
Audio output channels5.1 channels
Signal-to-Noise Ratio (SNR)98 dB
Total Harmonic Distortion (THD)1 %
Power output per channel (1KHz@6 Ohm)90 W
Power output per channel (1KHz@8 Ohm)70 W
Power output per channel (20-20KHz@8 Ohm)130 W
AirPlayNo
DisplayVFD
HDCP version2.2
Product colorBlack
Audio decodersDTS-HD, DTS-HD Master Audio, Dolby Pro Logic II, Dolby TrueHD
HDMI in5
Composite video in2
Digital audio coaxial in-
Supported graphics resolutions3840 x 2160
AM band range522 - 1611 kHz
FM band range87.5 - 108 MHz
Supported radio bandsAM, FM
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)0.5 W
Power consumption (typical)330 W
Number of HDMI outputs1
Connectivity technologyWired & Wireless
Speakers connectivity typeClamp terminals
Weight and Dimensions IconWeight and Dimensions
Depth319 mm
Width434 mm
Height151 mm
Weight7500 g

Related product manuals