Denon AVR-X6200W - Page 324

z1
The applicable sound mode includes “Dolby Surround” and sound modes that have “+Dolby Surround” in the sound mode name.
z2
The applicable sound mode includes “DTS Neural:X” and sound modes that have “+Neural:X” in the sound mode name.
z3
A signal for each channel contained in an input signal is output as audio.
z4 Audio is not output when “Speaker Config.” - “Surr. Back” in the menu is set to “1 spkr”. (v
p. 252)
z5 Audio is output from the speakers specified in the “Surround Parameter” – “Speaker Select” settings. (v p. 204)
z6
Audio is output from the speakers specified in the “Audyssey DSX
®
” settings. (v
p. 210)
z7 Audio is output when “Subwoofer Mode” in the menu is set to “LFE+Main”. (v p. 259)
Upgrade (Auro-3D)
.
Sound mode
Channel output
Front
L/R
Center
Surround
L/R
Surround
Back
L/R
Front
Wide
L/R
Front
Height
L/R
Top Front
L/R
Top
Middle
L/R
Top Rear
L/R
Rear
Height
L/R
Surround
Height
L/R
Top
Surround
Front
Dolby
Atmos
Enabled
L/R
Surround
Dolby
Atmos
Enabled
L/R
Back
Dolby
Atmos
Enabled
L/R
Subwoofer
Auro-3D
SDD D Dz8 DDz9 D
Auro-2D Surround
SDDD D
z8
You can use the Rear Height speakers instead of Surround Height speakers for Auro-3D playback. For best Auro-3D experience, using Surround Height speakers is
recommended.
z9
This is output if an Auro-3D signal is input and the input signal contains Top Surround.
Contents
Connections Playback Settings Tips Appendix
324
Front panel Display Rear panel Remote Index