Connecting an analog device
You can connect this unit to various devices with analog audio output.
This unit is compatible with turntables equipped with a moving magnet
(MM) phono cartridge. When you connect this unit to a turntable with a low
output moving coil (MC) cartridge, use a commercially available MC head
amp or a step-up transformer.
If you set this unit’s input source to “PHONO” and accidentally increase
the volume without connecting a turntable, you may hear a humming noise
from the speakers.
AUDIO
LR
OUT
L
R
L
R
GND
AUDIO
OUT
L
R
(MM cartridge)
Turntable
Analog device
NOTE
0
The earth terminal (SIGNAL GND) of this unit is not for safety grounding purposes.
If this terminal is connected when there is a lot of noise, the noise can be reduced.
Note that depending on the turntable, connecting the ground line may have the
reverse effect of increasing noise. In this case, it is not necessary to connect the
ground line.
Contents Connections Playback Settings Tips Appendix
24
Front/Top
panel
Rear panel
Remote control
unit
Index
To Next Page
Loading...
