14
Bluetooth connection problems
• If a Bluetooth fault occurs (the device moves out of range, or stops playing due to low battery or user input), DHT-S514’s Bluetooth LED
again blinks rapidly; the DHT-S514 will automatically attempt to re-connect, and will resume playback when the Bluetooth source is in
range. Note: On some devices you will need to press play again. Bluetooth’s effective wireless range varies with the source; (9 – 12 m) is
typical. If the source moves out of range, DHT-S514 will continue trying to re-connect it for 4 minutes; after that interval you will have to
re-connect, as above.
• Make sure DHT-S514 is not paired to a different Bluetooth source device.
• Make sure your desired Bluetooth source device is actually playing music or another audio program and is paired to DHT-S514 and not
some other device.
• On a multifunction source device such as a tablet or mobile phone, not every program or “app” may support Bluetooth audio broadcast
(consult the instructions for the program or app).
• Consider possible sources of interference, particularly those operating at 2.4 GHz (Wi-Fi routers, microwave ovens, landline cordless
telephones); power down suspects one at a time to identify a culprit. Often, repositioning an interfering device to another room, or even
across the room, will restore Bluetooth function.
DHT-S514 takes several seconds to turn on
• The DHT-S514’s power saving design puts the unit into standby mode after five minutes of no sound. DHT-S514 takes a few seconds to start
up the next time audio plays.
Factory reset
• Unplug sound bar from wall.
• Hold down Vol – (minus) button.
• Plug into power again.
• Standby button light will blink fast for several seconds indicating that the system has been reset.
• Clears Bluetooth pairing, remote learning, audio mode.
To Next Page
Loading...
