7
Control Command Codes
Use the codes below to control your DN-700R.
In cases where the control command code includes a variable, the variable is indicated in italicized font
and the potential values are indicated in bold font.
Control Commands
(Host ā DN-700R)
CATEGORY CONTENTS CODE DESCRIPTION
Power/Media
Power On @023PW\r Powers on DN-700R
Power Standby @02312\r Puts DN-700R in standby
Set Power On Mode @0POXX\r
Changes the default mode that DN-700R will
enter when it is powered on, where XX (the
mode) = RM (resume playback of the last played
track), PF (play the first track in the last used
folder), ST (stop playback), or RE (begin
recordin
to the last selected media source)
Select Media Source
@0MMXX\r
Selects the media source, where
X (the media
source) = S1 (SD Card 1), S2 (SD Card 2), US
(USB drive), or NE (Network)
Recording
Select Recording Input
@0INXX\r
Selects the input to be used as the recording
audio source, where XX (the input) = UB (the
RCA input), BA (the analog XLR input), DI (the
coaxial input), or DB (the AES/EBU input)
Set Recording Channels
@0CHXX\r
Sets whether recorded files will be set to stereo
or mono, where XX (the setting) = ST (stereo),
ML (left channel mono), or MX (mixed left and
right channel mono at ā3 dB)
Initiate Recording @02355\r
If One Touch Recording is set to off, the first
entry of this command puts DN-700R in
recording mode, and the second entry initiates
recording
If One Touch Recording is set to on, the first
entry of this command initiates recording
One Touch Rec On/Off
@0ORNN\r
Turns One Touch Recording on or off, where N
= 00 (on) or 01 (off)
Pause Recording @023Rp\r Pauses an in-progress recording
Split Recording @023MT\r
Splits an in-progress recording into two separate
files at the point the command is executed
Rec Monitor On/Off
@023RMNN\r
Turns the recording monitor feature on or off,
where NN = 00 (on) or 01 (off)
Set Input Volume Type @0VIXX\r
Determines whether the recording input volume
can be adjusted or whether it is fixed at 0 dB,
where XX = VA (can be adjusted) or FX (fixed at
0 dB)
Both Channel Volume
Up/Down
@023VX\r
Turns the volume of the recording up or down
1.0 dB for both the left and right channels, where
X (the direction) = + (up) or - (down)
To Next Page
Loading...
Need help?
General
