3
Introduction
Thank you for purchasing the DN-700R. At Denon Professional, performance and reliability mean as
much to us as they do to you. That’s why we design our equipment with only one thing in mind—to
make your performance the best it can be.
Support
For the latest information about this product (documentation, technical specifications, system
requirements, compatibility information, etc.) and product registration, visit denonpro.com.
For additional product support, visit denonpro.com/support.
General Overview
With serial remote control, a “host” machine (such as a PC running proper software) can be used to
operate your DN-700R. Throughout this document, the equipment used to control DN-700R will be
called the Host.
To learn more about the different types of serial communication and the code structure it requires, see
the Communication Protocol section that starts on the next page. To view the complete list of serial
command codes, see the Control Command Codes, Status Request Command Codes/Status
Information Codes, and Automatic Status Information Codes sections later in this manual.
Connecting the Host to DN-700R
For serial remote control, you must first connect the host to your DN-700R by taking one of the
following three steps:
Example 1
Use an RS-232C straight cable (9-Pin D-Sub Male) to connect the RS-232C input on the rear panel of
your DN-700R to the corresponding output on the host.
DN-700R Rear Panel
Personal Computer
RS-232C Straight Cable
To Next Page
Loading...
Need help?
General
