Denon DN-700R - Edit Function; Combining Audio Files; Dividing Audio Files

Part names and
Functions
Setting defaultsConnections
Selecting
Files and
Folders
Getting Started
Control
Function
Information
42
Selecting
Media
Recording Edit FunctionPlayback
Playback pitch adjustment (Pitch control)
The playback speed can be adjusted within a range of –16 % to +16
%.
By adjusting the pitch, you can listen to recordings over a shorter time
span, or listen more slowly to difficult to hear sections.
1
Press PITCH while holding down SHIFT during
playback, cue or when stopped.
The pitch LED lights and pitch adjustment is enabled.
2
Press PITCH + or PITCH – while holding down SHIFT.
•The pitch changes by 0.1% each time the button is pressed.
•Press and hold the button to change the pitch continuously.
•To cancel the pitch control, press PITCH again while holding down
the SHIFT button.
n To change the pitch without altering the
musical interval, use (master key).
When the playback speed is adjusted using the pitch control, the
musical interval changes according to the playback speed.
When the master key function is on, the playback sound is played
back without changing the musical interval even if the pitch is
adjusted.
•For details on the key control settings, see “32 Master Key”
(vpage20) in “Preset Setting”.
When “32 Master Key” is set to “On”, “J” appears in the
display.
Operations during playback
Add marks (marking)
By writing marking information in files, you can search for marks and
play back from a certain point.
During playback or in the stopped state, hold down
SHIFT and press MARK.
A mark is added at the point when you press it.
When a mark is added, “Mark z” (z: number of marks) is displayed.
•You can write up to 30 marks in a file.
•You can edit marks with the supplied software “DMP Mark Editor”.
For more information, see the instruction manual for “DMP Mark
Editor” on the supplied CD-ROM.
NOTE
•You cannot add marks to MP3 files that are not recorded by DN-700R.
•You cannot add marks when files are recorded in VBR.
Searching for Marks
During playback, cue or in the stopped state, hold down
SHIFT and press MARK + or MARK –.
•When MARK + is pressed, the track is forwarded to the next
marked point and paused.
•When MARK – is pressed, the system returns to the previous
marked point and is paused.
Marks can only be searched within the current file.
Random playback
1
Set “21 Random” (vpage 19) in “Preset Setting”
to “On”.
2
Press PLAY.
Tracks are selected at random and playback starts.