Denon DR-M22 - Component Identification and Functions; POWER switch; TIMER switch; EJECT button

OOOO ©
DENON 6 snepossicent mecnanisw
CMEC)
1. POWER switch
Controls the supply of AC power to the
deck. One push turns the deck on, a second
push turns it off. The deck remains in a
stand-by (non-operative) mode for approxi-
mately 4 seconds after it is switched on.
2. TIMER switch
This switch is provided for use with an
optional audio timer for unattended recording
or morning-alarm playback. For non-timer
operation, this switch should be set in the
“off’position (see page 14).
3° EJECT button
Press this button to eject the cassette.
When the deck is operating (tape is running),
press thestop (Mf) key first to stop the tape
transport; then press the EJECT button.
@ ©)
Fig. 1
4. Cassette compartment cover
If this compartment cover is not closed
completely, the deck’s transport controls will
remain inoperative.
5. TAPE COUNTER
A four-digit readout indicates the present
tape count position.
6. DOLBY NR switches
The left Dolby NR switch activates (in) or
deactivates (out) the deck’s Dolby noise
reduction circuitry. The right switch selects
between Dolby B-Type (out) or C-Type NR (in).
(see page 9).
7. MONITOR switch
The SOURCE (in) position of this switch
® ©D DOOM
allows you to monitor the source program
before it is recorded. The TAPE (out) position
of this switch is used for tape playback
monitoring or simultaneous monitoring during
recording (see page 13).
8. BIAS FINE ADJ control
(for NORMAL and CrO, tape)
Adjust the bias according to the tape
characteristics. Standard biasing is obtained
at the center click-stop position. (see page
13).
9. FLUORESCENT PEAK METERS
These meters indicate recording or playback
peak levels for each channel.
10. TAPE SELECT indicator
This indicator light is interlocked with the
Auto Tape Select feature which automatically
adjusts the deck to the type of tape in use.
(NORMAL, CrOz, or METAL).
11. OUTPUT LEVEL control
This control adjusts playback, recording
monitor, and headphones output levels for the
both channels simultaneously.
12. NR SYSTEM indicator
This indicator light is interlocked with the
Dolby NR switch and informs the user that
Dolby NR is in use as well as which (B or C)
Type.
13. MONITOR indicator
This indicator light is interlocked with the
= 6 =