Denon DRA-N5 - Servicing Precautions and Procedures; WLAN Module Replacement; Network Receiver Initialization

10
ABOUT REPLACE THE WLAN MODULE WITH A NEW ONE
When replaced of the DRA-N5 WLAN MODULE (E3:963189100330D
）（
E2:963189100340D
）（
JP:963189100350D),
conrm contents of the following.
(1) Replace the WLAN MODULE with the 963189100330D/963189100340D/963189100350D (MAC Address was
written).
(2) The rmware is updated by DPMS. Refer to [ VERSION UPGRADE PROCEDURE OF FIRMWARE "1. How to
update by DPMS" ] (page 33) for the details of the Version up.
(3) MAC Address Label pasted to Bottom is pasted to Mac Address Label (GEN8341; MAC ADDRESS SUB ASSY) of
exchanged WLAN MODULE and it substitutes it.
InitializingNETWORKRECEIVER
NETWORK RECEIVER initialization should be performed when the μ-com, peripheral parts of μ-com, and Digital PCB.
are replaced.
1. Turn off the power using ON/STANDBY button, unplug the power cord.
2. Plug the power cord into a power outlet while pressing VOLUME ▲ and CURSOR
i
button simultaneously.
(Factory Reset)
3. Turn off the power using ON/STANDBY button, unplug the power cord.
4. Plug the power cord into a power outlet while pressing VOLUME ▲ and ▼ button simultaneously.
(Initialized)
Note: * All user settings will be lost and this factory setting will be recovered when this initialization mode. So
make sure to memorize your setting for restoring after the initialization.
PUSH OPEN
VOLUMEdVOLUMEf CURSORi
CAUTION IN SERVICING