Why is the picture distorted on my Denon CD Player?
Sometimes a small amount of picture distortion may appear on your Denon CD Player. This is not a malfunction. Try connecting the player directly to the TV.
What to do if my Denon CD Player does not return to start-up screen when disc is removed?
If your Denon CD Player does not return to the start-up screen when the disc is removed, reset the player by turning it off, then on again.
Why does the angle not switch on my Denon CD Player?
The angle cannot be switched for DVDs on your Denon CD Player which do not contain multiple angles. In some cases, multiple angles are only recorded for specific scenes.
Why does playback not start when the title is selected on my Denon CD Player?
If playback does not start when the title is selected on your Denon CD Player, check the RATINGS setting.
Audio Specifications| frequency response (DVD) | 4 Hz - 22 kHz (48kHz sampling), 4 Hz - 44 kHz (96kHz sampling), 4 Hz - 88 kHz (192kHz sampling) |
|---|---|
| frequency response (CD) | 4 Hz - 20 kHz |
| frequency response (Super Audio CD) | 4 Hz - 100 kHz |
| signal-to-noise ratio | 115 dB |
| dynamic range (DVD) | 100 dB |
| dynamic range (CD) | 98 dB |
| total harmonic distortion (1 kHz CD) | 0.004% |
Video Specifications| signal system | NTSC |
|---|---|
| composite video output | 1.0 Vp-p (with 75 ohms load) |
| S-Video output (Y) | 1.0 Vp-p (with 75 ohms load) |
| S-Video output (C) | 0.286 Vp-p |
| component video output (Y) | 1.0 Vp-p (with 75 ohms load) |
| component video output (Pb/Cb) | 0.648 Vp-p (with 75 ohms load) |
| component video output (Pr/Cr) | 0.648 Vp-p (with 75 ohms load) |
| HDMI Output | ver1.1 |
General Specifications| power supply | AC 120 V, 60 Hz |
|---|---|
| power consumption | 15 W |
| power consumption (standby) | 1 W |
| dimensions | 435 (W) x 75 (H) x 310 (D) mm |
| dimensions (inches) | 17-3/32” (W) x 2-61/64” (H) x 12-13/64” (D) |
| weight | 2.6 kg |
| weight (lbs) | 5.72 lbs |
To Next Page
