What to do if Denon DVD-3930CI DVD Player remote control is not working?
If the remote control isn't working, try these steps: First, make sure the batteries are inserted correctly, matching the < and > marks. If they are, replace them with new batteries. When operating, point the remote at the remote control sensor from within 7 meters and ensure there are no obstacles in the way.
What to do if picture does not appear with HDMI connections on Denon DVD-3930CI DVD Player?
If you're not getting a picture with HDMI, first, check the HDMI connections and the lighting conditions of HDMI-related indicators. Next, ensure the compatible input formats of your connected monitor device match the DVD-3930CI’s input format (HDMI FORMAT). Finally, verify that “VIDEO OUT” in the pure direct settings is not set to “OFF” or “ALL OFF.”
How to reset forgotten password on Denon DVD Player?
To reset a forgotten password for viewing restrictions, reset all initial setting values to the factory defaults. In stop mode, simultaneously press the 1 and 9 buttons on the main unit. Ensure that the “INITIALIZE” indicator turns off from the TV screen.
Why does my Denon DVD Player have no sound or the sound is hard to hear?
If you're experiencing sound issues, first, check all the connections. Then, set the proper inputs (TV, stereo, etc.). Also, check the “DIGITAL OUTPUT” and “COMPRESSION” settings. Note that digital signals are not output for Super Audio CDs, so use analog or DENON LINK 3rd connections. If using HDMI, ensure that “VIDEO OUT” or “DIGITAL OUTPUT” in the pure direct settings is not set to “OFF” or “ALL OFF”. Also, be aware that when HDMI connections are made with a device not compatible with HDMI Ver. 1.1, the audio signals of DVD-Audio discs that are copyright protected with CPPM are not output.
What to do if picture does not appear on Denon DVD-3930CI DVD Player?
If the picture does not appear, check the connections first. Then, check whether “VIDEO OUT” in the pure direct settings is set to “OFF” or “ALL OFF”. Finally, ensure the TV’s input is set to “video.”
What to do if subtitles are not displayed on Denon DVD-3930CI?
If subtitles are not showing, it may be because the DVD does not contain subtitles. If the DVD has subtitles, ensure that subtitles are enabled in the settings.
Why does playback not start or stops immediately on Denon DVD-3930CI?
Playback might not start, or it might stop immediately, due to condensation. If condensation is the issue, let the unit sit for 1 or 2 hours. Also, ensure you're using a compatible disc. Finally, wipe any dirt off the disc or try replacing it.
How to fix the wrong aspect ratio on Denon DVD-3930CI?
If the picture is not displayed in the correct 4:3 (16:9) aspect ratio, set the “TV ASPECT” and “SQUEEZE MODE” items properly according to your TV. Also, either set the keystone correction setting to “0” or readjust it.
Why the audio or subtitle language is not the language set in the initial settings on Denon DVD-3930CI DVD Player?
If the audio or subtitle language isn't what you set in the initial settings, it's likely because the DVD doesn't contain sound or subtitles in your selected language.
Why I Cannot switch the angle on my Denon DVD Player?
The angle cannot be switched unless the DVD contains more than one angle. In some cases, multiple angles are only provided for specific scenes.
General| Brand | Denon |
|---|---|
| Model | DVD-3930CI |
| Category | DVD Player |
| Language | English |
To Next Page
