My HEOS device turns off and the status LED flashes in red
Solution Refer to Page
0
The protection circuit has been activated due to a rise in temperature within your HEOS device. Turn the power off, wait about
an hour until this device cools down sufficiently, and then turn the power on again.
–
0
Check the speaker connections. The protection circuit may have been activated because speaker cable core wires came in
contact with each other or a core wire was disconnected from the connector and came in contact with the rear panel of this
device. After unplugging the power cord, take corrective action such as firmly re-twisting the core wire or taking care of the
connector, and then reconnect the wire.
13
Contents Setup Use Troubleshooting Status LED Appendix
45
To Next Page
Loading...
