.
Playing digital input
1
Prepare for playback.
Check the connection, then turn on this units. (“Connecting a digital
device” (v p. 26))
2
Press OPTICAL IN to switch the input source to
“Optical In 1” or “Optical In 2”.
3
Play the component connected to this unit.
0
If the sampling frequency cannot be detected, “Signal Unlock” will
be displayed.
0
“Unsupported” is displayed when audio signals that are not
supported by this unit are input.
Contents Connections Playback Settings Tips Appendix
71
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
