Switching the display’s brightness
The display brightness can be adjusted between five levels.
1
Press DIMMER.
0
The brightness of the display switches each time the button is
pressed.
0
If the buttons are operated when the display is turned off, information is displayed
temporarily at a low brightness level.
0
The display brightness is set to most brightly by default.
Using the sleep timer
You can have the power automatically switched to standby once a set time
has elapsed. This is convenient for listening while going to sleep.
1
Press SLEEP during playback and select the setting
time.
0
The o indicator on the display lights.
0
The sleep timer can be set to up to 90 minutes, in steps of 10
minutes.
0
After about 5 seconds, the setting is entered and the display
returns to as it was before.
o
To cancel the sleep timer
1
Press SLEEP to set “Sleep 1 Off”.
The o indicator on the display turns off.
0
The sleep timer setting is canceled when the unit switches to standby mode.
0
To check the time remaining until the sleep timer is activated, press SLEEP.
Contents Connections Playback Settings Tips Appendix
81
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
