General
Alarm
Audio from the set input source can be played back at a specified time.
Use this to set playback for the same time every day, or set alarm
playback on a certain day of the week.
o
Alarm 1
On: Enables Alarm 1.
Off: Disables Alarm 1.
o
Alarm 2
On: Enables Alarm 2.
Off: Disables Alarm 2.
o
Edit Alarm
Used to edit Alarm 1 or Alarm 2.
1
Use ui to select “Alarm 1” or “Alarm 2”, then press
ENTER.
2
Use ui to setting for the alarm start time, then press
ENTER.
3
Use ui to change to desired setting, then press
ENTER.
Never: Alarm is not repeated. (single time only)
Everyday: Alarm is repeated every day.
Weekdays:
Alarm is repeated on weekdays (Mon.
to Fri.) only.
Weekends:
Alarm is repeated on weekends (Sat.,
Sun.) only.
Custom:
Used to set alarm on/off settings
individually for each day of the week.
Alarm is repeated only for days set to
on.
4
Use ui to select the input source, then press ENTER.
CD / Tuner / Optical In 1 / Optical In 2 / Analog In
0
When “Tuner” is selected, select a preset number.
5
Use ui to select the volume level “00 – 100”, then
press ENTER.
The display shows “Complete!!” and the setting is completed.
Contents
Connections Playback Settings Tips Appendix
96
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
