Audio from digital devices cannot be played back (Coaxial/Optical)
“Signal Unlock” is displayed.
0
When digital audio signals cannot be detected properly, “Signal Unlock” is displayed. (v p. 74)
“Unsupported” is displayed.
0
“Unsupported” is displayed when audio signals that are not supported by this unit are input. Check the audio output signal format from your digital
device. (v p. 74)
The input source switches to “Optical 1”, “Optical 2” or “Coaxial”
The input source automatically switches to “Optical 1”, “Optical 2” or “Coaxial” when the TV connected to this unit is turned on.
0
Set “Off” to “Auto-Play”. (v p. 94)
The input source automatically switches to “Optical 1”, “Optical 2” or “Coaxial” regardless of the TV connected to this unit is turned off.
0
Some TVs output digital signals even when the power is off. When using this unit with such TVs and a digital connection, its “Auto-Play” function may
activate regardless of the TV is turned off. The following settings link this unit to television remote control power on operations to enable automatic
playback through television audio.
A
Set the “Auto-Play” function in the settings menu to “Off”. (v p. 94)
B
Use the “IR Control” function in the settings menu to set “Input Optical In 1”, “Input Optical In 2” or “Input Coaxial In” operation to the power button of
your TV’s remote control. (v p. 95)
0
Set according to the terminal (OPTICAL 1, OPTICAL 2 or COAXIAL) of this unit that is connected to the TV.
Contents Connections Playback Settings Tips Appendix
125
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
