o
Playback in ANALOG MODE
When the ANALOG MODE is turned on to playback an analog source
(PHONO, CD, NETWORK, RECORDER), power to the digital input
circuit and the display turn off. This enables you to enjoy high sound
quality audio playback without sound quality being affected by noise
that occurs from the digital control circuit.
1
Press ANALOG MODE to turn analog mode on.
0
The ANALOG MODE indicator lights.
Press ANALOG MODE to toggle between
“ANALOG MODE Off”,
“ANALOG MODE 1” and “ANALOG MODE 2”.
ANALOG MODE Off: ANALOG MODE is not used.
ANALOG MODE 1: Turns the digital input circuit power off.
ANALOG MODE 2:
Turns the digital input circuit power and
display off.
0
A digital input source (COAXIAL, OPTICAL 1/2, USB-DAC) cannot be selected
when ANALOG MODE is on.
0
The input source automatically switches to CD if ANALOG MODE is turned on
during playback of a digital input source (COAXIAL, OPTICAL 1/2, USB-DAC).
0
Communication between this unit and the computer is disconnected if ANALOG
MODE is turned on when a computer is connected to the USB-DAC input
connector of this unit. If the unit cannot communicate with the computer after
turning ANALOG MODE off again, disconnect and reconnect the USB cable or
restart the audio player on the computer.
0
When the analog mode is switched, the mute circuit is activated for about 5
seconds.
Contents Connections Playback Settings Tips Appendix
30
Front panel Rear panel
Remote control
unit
Index
I
V
\
I
V V \
I
_ -
I
_ -
0
To Next Page
Loading...
