Denon POA-F100 - Wiring and Schematic Diagrams; Wiring Diagram

[ZZ POA-F100
~ SCHEMATIC DIAGRAM
16
aes
KSC1845
noes
ZB
fal s[ulul—] spies
eecrrznneneeanrenaneceneeaaaaneaeeeeneeeeaesaneeaannaneaaneeaeoenacaveaneeeeneaagatseevenavneeennsnartenzrveeaneneaesea py af wf! eaecununnnaeeanawaeaernewnevenenragy
! ii
«
: 2
NO 3}
ree a L270) Oise
ze @. 15s
iT EN 4 R228 on? Rance
Lt ENTE Ft on7 1174 A 5 %
Yh JOU q Sr ,
i S-F Oo
@7H-M RL27
cis4
C303 190P
BSawewneaan hee neazawmeenrmeowmeocewne ese See ee seen swan aneeseweveeseawreaunnnanwraavnan jaa} wfartuny afuslol— | Pcer
wavwhzhernancnaace e@eaoanatvraaoeereeae
ae | amktncen
Ui 228 0582 1N4eR4
BCS!7 4 ue
00/5 bse) iweoed
ra Hf
168/35
TEMPERATURE
PROTECTION :
:
SF
BLINE
a See BY
ae ee 8 LINE
~15V
SCHEMATIC DIAGRAM —--—
MAIN
UNIT
:
7
AMP UNIT
LED UNIT
POWER SW UNIT
SIGNAL (S-Lch)
NOTICE
ALL RESISTANCE VALUES IN OHM. k=1, 000 OHM M=1,000,000 OHM
ALL CAPACITANCE VALUES I N MICRO F-ARAD. P=MICRO-MICRO FARAD
EACH VOLTAGE AND CURRE NT ARE ME-ASUERD AT NO SIGNAL INPUT
CONDITION.
CIRCUIT AND PARTS ARE SUBJECT TO CHANGE WITHOUT PRIOR
NOTICE.
WARNING:
Parts marked with this symbol AEEShave critical characteristics.
Use ONLY replacement parts recommended by the manufacture.
CAUTION:
Before retuming the unit to the customer, make sure you make either (1) a
leakage current check or (2) a line to chasssis resistance check. If the leakage
current exceeds 0.5 milliamps, or if the res stance from chassis to either side
of the power card is less than 460 kohms, the unit is defective.
WARNING:
DO NOT retum the unit to the customer uretil the problem is located and
corrected.