Listening to preset stations
1
Use 0 – 9, +10 or CHANNEL –, + to select the preset
number.
Setting the preset channels and
changing the received frequency on
the main unit
Preset/Tuning buttons (–, +) on the main unit can be used both for
switching the preset channel and for tuning.
Before operating them, switch the main unit to the “PRESET MODE” or
“TUNING MODE” using the procedure below.
1
Press SETUP.
2
Use ui to select “TUNER SETUP”, then press ENTER.
3
Use ui to select “MODE SELECT”, then press ENTER.
4
Use ui to select “PRESET MODE” or “TUNING MODE”,
then press ENTER.
PRESET MODE:
Use Preset/Tuning buttons (–, +) on the
main unit to switch preset channels.
0
This is the same operation as
CHANNEL – or CHANNEL + on the
remote control unit.
TUNING MODE:
Use Preset/Tuning buttons (–, +) on the
main unit to change the received
frequency.
0
This is the same operation as TUNE
– or TUNE + on the remote control
unit.
Contents Connections Playback Settings Tips Appendix
34
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
