CLOCK SETUP
Sets the current time.
1
Use ui to set the “hours”.
2
Press ENTER.
The “minutes” display flashes.
3
Use ui to set the “minutes”.
4
Press ENTER.
The current time is set, and the menu display disappears.
n
Checking the current time when the power is on
Press CLOCK.
Press once more and the display returns to its original condition.
n
Checking the current time when the power is set to
standby
Press CLOCK.
The current time is displayed for 10 seconds.
0
The time cannot be set when in the standby mode. Turn on the power first.
ALARM SETUP
Audio from the set input source can be played back at a specified time.
Audio can also be played at the same time every day.
1
Use uio p to change to desired setting, then press
ENTER to enter the setting.
A
MODE SELECT
Use ui to select the alarm mode, then press ENTER.
ONCE ALARM:
Playback starts and stops (the power
turns off) once only at the set times.
EVERYDAY ALARM:
Playback starts and stops (the power
turns off) at the set times each day.
B
SOURCE SELECT
Use ui to select the source, then press ENTER.
DISC / TUNER / ANALOG IN / OPTICAL IN 1 / OPTICAL IN 2 /
Bluetooth
0
If you have selected “TUNER” in “SOURCE SELECT”, select the Preset
Number.
0
When no name has been registered for the selected preset number, the
frequency appears after the preset number is displayed.
0
When “Bluetooth” is selected, this unit attempts to connect to the
previously connected device.
0
The alarm may not work on some Bluetooth devices.
Contents Connections Playback Settings Tips Appendix
53
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
