S
savagetimothyAug 31, 2025
What to do if my Denon Receiver display is off?
- JJennifer MedinaAug 31, 2025
If the display is off on your Denon Receiver, the Dimmer setting may be set to “OFF.” Set it to something other than “OFF.”
To Next PageTo Next PageWhat to do if my Denon Receiver display is off?
If the display is off on your Denon Receiver, the Dimmer setting may be set to “OFF.” Set it to something other than “OFF.”
Why does my Denon Receiver not operate properly?
The set may not operate properly because external noise or interference is causing the set to malfunction. Reset the microprocessor.
How to resolve hissing or continuous noise when receiving AM programs on my Denon Receiver?
Hissing or continuous noise during AM program reception on your Denon Receiver can be due to TV noise or broadcast station interference. Try turning off the TV. You can also try changing the position and direction of the AM loop antenna.
Why is the TV sound not outputting on my Denon Receiver?
If you're not getting TV sound from your Denon Receiver, it might be because the receiver's AUX IN 3 (OPTICAL) terminal cannot input digital audio signals other than 2 channel linear PCM. Set the digital audio output setting of the TV to 2 channel PCM.
How to resolve continuous noise when receiving FM programs on my Denon Receiver?
To resolve continuous noise when receiving FM programs on your Denon Receiver, ensure the antenna cable is properly connected. If the issue persists, consider connecting an outdoor antenna.
What to do if my Denon Receiver displays “No Network Connection”?
If your Denon Receiver displays “No Network Connection”, it could be due to an improperly set up network. Perform “Network First Setup.” Alternatively, try selecting a source other than the network function.
How to fix a Denon Receiver that does not work properly when the remote control is operated?
If your Denon Receiver isn't responding to the remote control, consider the following: * Replace worn batteries with new ones. * Ensure you are operating the remote within the specified range. * Remove any obstacles between the main unit and the remote. * Verify the batteries are inserted correctly, matching the polarity marks. * Move the set away from strong light sources that may interfere with the remote control sensor.
What to do if my Denon Receiver display is lit but no sound is produced?
There are several reasons why your Denon Receiver might have a lit display but no sound: * The input source may be incorrect; select the appropriate input source. * The volume control may be set too low; turn the volume up. * MUTING may be activated; switch off MUTING.
Why does my Denon Receiver power off suddenly and POWER indicator flashes red (0.25 second intervals)?
Turn off the power and contact a DENON service center.
Why does my Denon Receiver power off suddenly and the POWER indicator flashes red (0.5 second intervals)?
This issue occurs when core wires of two speakers are touching, or a core wire is sticking out and touching the set’s rear panel, activating the protection circuit. To resolve this, first unplug the power cord. Then, twist the core wires tightly or terminate the speaker cables before reconnecting the power.
General| Frequency range | 5 - 20000 Hz |
|---|---|
| RMS rated power | 65 W |
| Pre-out channels | 1 SW |
| Input sensitivity | 200 mV |
| Pre-out connectivity | Yes |
| Audio output channels | 2.0 channels |
| Signal-to-Noise Ratio (SNR) | 100 dB |
| Total Harmonic Distortion (THD) | 0.7 % |
| Dynamic power per channel (4 Ohm) | 80 W |
| Power output per channel (20-20KHz@8 Ohm) | - W |
| Audio (L/R) in | 2 |
| Digital audio optical in | 1 |
| Headphone connectivity | 3.5 mm |
| Connectivity technology | Wired & Wireless |
| Speakers connectivity type | Binding post |
| Audio formats supported | AAC, FLAC, MP3, WMA |
| Image formats supported | JPG |
| Video formats supported | AVI, WMV |
| AM band range | 522 - 1611 kHz |
| FM band range | 87.5 - 108 MHz |
| Supported radio bands | AM, FM |
| Preset stations quantity | 99 |
| Internet radio services supported | Last.fm, Napster |
| Optical drive type | CD player |
| Disc types supported | CD, CD-R, CD-RW |
| Display | OLED |
| Product color | Silver |
| Audio decoders | Not supported |
| Volume control | Rotary |
| Apple docking compatibility | iPhone, iPod |
| Number of products included | 1 pc(s) |
| AC input voltage | 230 V |
| AC input frequency | 50 Hz |
| Power consumption (standby) | 0.4 W |
Weight and Dimensions| Depth | 299 mm |
|---|---|
| Width | 280 mm |
| Height | 112 mm |
| Weight | 4300 g |
