ENGLISH
I
<MUTE/SNOOZE>
<~>
<~/II>
<~>
About
the
button names in these explanations
< > . Buttons
on
the main unit
[ I : Buttons
on
the remote control unit
Button
name
only:
Buttons
on
the main unit
and
remote control unit
28
Convenient Functions
Personal
Memory
Plus Function
This function sets the settings last selected for the
individual input sources.
When you switch to
an
input source, the settings
are
automatically set to the ones that were set the last time
that input source was used.
Last Function
Memory
This stores the settings
as
they were directly before the
standby mode was set.
When the power
is
turned back
on,
the settings
are
restored to
as
they were directly before the standby mode
was set.
Backup
Memory
The various settings
are
backed
up
for about 1 week,
even if the power
is
turned off or the power cord
is
disconnected.
Auto Power On
When the power
is
in
the standby mode, the power turns
on
simply by pressing
<~>
or
<~III>.
Resetting the Microprocessor
Perform this procedure if the display
is
abnormal or if
operations cannot
be
performed.
When the microprocessor
is
reset.
all
the settings
are
reset to their default values.
1Remove the power plug.
2
While pressing
<~>
and
<MUTE
I
SNOOZE>
simultaneously, plug the power cord into a power outlet.
3
When "INITIALIZE" is displayed, release your
fingers from the two buttons.
#
When "INITIALIZE"
is
not displayed
in
step
3,
repeat operations from
step 1
To Next Page
Loading...
