2.4. Features
ON/OFF
:
Press this button start the handpiece. Press
this button again to turn on the curing light. Pressing
this button during the curing cycle will interrupt and
end the cycle. If the unit is in sleep mode, press this
button will wake the unit and it will display with the last
mode choosen.
Screen
:
Display second.
MODE
:
Push the MODE button, the time would be
changed as followed 10 secs
→
20 secs
→
30 secs
→
40
a
b
c
2.5. Display
b
c
a
Different modes and output power would be displayed on the screen as below:
Stand mode output 10 seconds.
Ramp mode output 20 seconds.
Ramp mode output 30 seconds.
Stand mode output 40 seconds.
4
To Next Page
Loading...
