What to do if the Dentmate LEDEX WL-090 Dental equipment intensity is too low?
If the intensity test result in Standard mode is under 700 mW/cm2, and the output remains too low, it is recommended to contact your dealer for assistance.
What to do if Dentmate LEDEX WL-090 does not turn on?
If your Dentmate Dental equipment does not turn on, remove the battery and reinsert it. If it still doesn't work, plug the power supply into the cradle and charge the battery for at least 10 minutes. Then, try pushing the ON/OFF button again.
Why does the Dentmate Dental equipment display show an overheat sign?
If your Dentmate Dental equipment displays an overheat sign, it means the temperature has risen significantly. Please wait a moment for it to cool down before using it again.
How to fix Dentmate LEDEX WL-090 that does not charge?
If your Dentmate Dental equipment battery is not charging, begin by cleaning the battery contacts. If the issue continues, replace the battery with a new one.
Explanation of symbols used within the instruction manual text.
Identification of symbols found on the product or its packaging.
Specifies the intended use of the LEDEX™ WL-090 dental curing light.
Specifies the intended user qualifications and the device's purpose.
Details safe operating and storage environmental requirements.
General| Light Intensity | 1, 200 mW/cm² |
|---|---|
| Wavelength | 440-480 nm |
| Battery | Rechargeable Lithium-ion battery |
| Light Source | LED |
| Power Output | 5W |
| Battery Type | Lithium-ion |
| Charging Time | 2 hours |
| Battery Life | Approximately 500 charge cycles |
| Operating Time | Approximately 90 minutes |
| Applicable Materials | Composite resins, adhesives, and other light-cured dental materials |
To Next Page
