1. Connect the power supply to AC100~240 V electronic
socket and plug-in the connector to the cradle. Put the
handpiece into the cradle to charge the battery.
2. When the battery is in a low status, the display of the
handpiece will glow and show the of low battery sign.
3. When the battery is fully charged, the display of the
handpiece will glow and show the of full battery sign.
4. When the battery is charging, the display of the handpiece
will glow and show the sign of charging battery.
2.6. Operating modes
Each time, disinfect surfaces of the curing light, light probes and, anti-glare cones
before using.
Select curing programs and curing time. The curing programs and the curing time
can be individually set. LEDEX
TM
WL-090 is equipped with the following 6 curing
programs for different indications. Use the mode selection buttons to choose
the curing programs. The display will change accordingly (see Indicators on the
handpiece). The device comes equipped with the following preset programs :
6
EN
To Next Page
Loading...
