EasyManua.ls Logo

Dentmate LEDEX WL-090 - Page 24

Dentmate LEDEX WL-090
27 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Immunity test
IEC60601-1-2
test level
Compliance
level
Electromagnetic environment-
guidance
Conducted RF
IEC 61000-4-6
Radiated RF
IEC 61000-4-3
3 Vrms
150 kHz to
80 MHz
80 %AM(2 Hz)
3 V/m
80 MHz to
2.5 GHz
80 %AM(2Hz)
3 Vrms
3 V/m
Portable and mobile RF
communications equipment should
be used no closer to any part of the
LEDEX
TM
WL-090, including cables,
than the recommended separation
distance calculated from the
equation applicable to the frequency
of the transmitter.
Recommend separation distance
d=1.2√P150kHzto80MHz
d=1.2√P80MHzto800MHz
d=2.3√P800MHzto2.5GHz
where P is the maximum output
power rating of the transmitter
in watts (W) according to he
transmitter manufacturer and d is the
recommended separation distance in
meters (m).
FieldstrengthsfromxedRF
transmitters as determined by an
electromagnetic site surveyª, should
be less than the compliance level in
each frequency range
b
.
Interference may occur in the vicinity
of equipment marked with the
following symbol
Note1 : At 80 MHz and 800 MHz, the higher frequency range applies.
Note2 : These guidelines may not apply in all situations. Electromagnetic propagation
isaffectedbyabsorptionandreectionfromstructures,objects,andpeople.
1. Field strengths from fixed transmitters, such as base stations for radio (cellular/
cordless) telephones and land mobile radios, amateur radio, AM and FM radio
broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess
theelectromagneticenvironmentduetoxedRFtransmitters,anelectromagneticsite
surveyshouldbeconsidered.Ifthemeasuredeldstrengthinthelocationinwhich
the LEDEX
TM
WL-090 is used exceeds the applicable RF compliance level above,
the LEDEX
TM
WL-090 should be observed to verify normal operation. If abnormal
performance is observed, additional measures may be necessary, such as reorienting
or relocating the LEDEX
TM
WL-090.
2. Overthefrequencyrange150kHzto80MHz,eldstrengthsshouldbelessthan3V/m.
21

Related product manuals