Eng-4
Section 2: Stand Installation
Keep the foam underneath the monitor before attaching the stand.
1. Open the package, take out the product with foam still attached, and gently
place it on a desktop or table.Next, use the included screwdriver and three NO.1
screws to fasten the base to the stem.
2. Remove the foam covering the back of the monitor,the press the button to
remove the stand plate.Nex,use two NO.1 screws to fasten the stand plate to
the stem.
Stand Stem
Base
NO.2 Screws 14mm
x3
NO.1 Screws 14mm
12mmx2
Stand Plate
Button
3. Insert the stand’s plate into the opening on the back of the monitor. It should
click into place. Make sure the stand is securely attached to the back of the
monitor then remove the monitor from the remaining foam section and stand
it up on a table or desk.
If needed, the stand can easily be detached from the monitor by pressing the
button near the stand plate. Make sure the monitor is laid on a flat surface
before removing the stand.
Button
Monitor
Stem
Stand Plate
To Next Page
Loading...
Need help?
General
