Eng-7
DP
HDMI
Solid blue light indicates power is on and the monitor is operating normally.
Flashing blue light indicates no video source has been detected. Red light
indicates that no horizontal or vertical signal has been detected or voltage is
low. Please ensure your computer is on and all video cables are fully inserted
and/or connected.
Indicator Light
Section 5: Basic Operation
1. Insert one end of the DP cable into your PC’s graphics card.
For optimal refresh rate (or “performance”), it is recommended to use a DP
cable with the monitor’s corresponding connector.
2. Connect the other end of the cable to the corresponding connector on your
monitor. See the image below.
3. Connect the power cable to your monitor then connect the other end to your
power source. It is recommended that you use a surge protector with adequate
voltage if a wall outlet cannot be reached directly.
4. Locate the power button on the monitor and press it to turn the monitor on.
If you cannot locate the power button, please refer to Section 1.1.
Section 6: Indicator Light
This light is located on the bottom of the monitor.
Bottom View
HDMI
AUDIO
To Next Page
Loading...
Need help?
General
