SETUP & BASIC OPERATION
Power Connection
Make sure that operating voltage of the unit corresponds to your home mains
voltage. Your unit can be connected to a 5V DC adaptor.
Connecting to External Audio System
You can listen to your turntable using the built-in speakers but you may wish to
connect it to your existing audio system. Connect the audio plugs to the Line
input on your mixer or amplifier using an RCA cable (not supplied).
- Red plug into R channel input.
- White plug into L channel input.
Playing a Record
Place the record of your choice on the turntable. If required, do not forget to
place the 45 RPM adaptor on the record spindle.
Choose the desired playing speed using the speed selection switch between
33.3, 45 and 78 RPM. Turn on the Rotary Power Switch, note that this also
controls volume.
Release the tone arm lock.
Carefully raise the tone arm.
Place the stylus vertically over the first track of the record, the turntable will
start turning automatically.
Lower the tone arm slowly on to the record to play.
When a record comes to the end, the turntable will stop automatically if the
auto-stop switch is in the ON position. If the switch is in the OFF position then it
will keep revolving until the tone arm is returned to the tone arm rest.
Lift up the tone arm and replace it on the tone arm rest.
Replace the protective cap on the stylus and close the tone arm lock.
Turn off power.
ENG 4
To Next Page
Loading...
